Qradar OpenVPN
Hi everyone,
I use Qradar 7.3.0 Build 20170927150848.
I try to do a VPN connection between a collector, which is on my computer, and a Console, which is on another subnet belong to my enterprise.
I follow the following documentation for the console part : https://www.ibm.com/support/knowledgecenter/ro/SS42VS_7.2.6/com.ibm.qradar.doc/t_cloud_server_vpn_.html and the following documentation for the collector part : https://www.ibm.com/support/knowledgecenter/ro/SS42VS_7.2.6/com.ibm.qradar.doc/t_cloud_client_vpn.html?view=embed
For the Console part, there is no file named "enable". So, at the 3d point, the Console say : "-bash: /opt/qradar/bin/enable: No such file or directory" For the Collector part, I can't going forward than the 1rst step and say : "Failed to run command 'addclient': 'host.role'.
Is there any other updated documentation or anything that I didn't do well ?
Kind regards,
Vincent.
There's a typo in the document. You're looking for
/opt/qradar/bin/vpntool enable
Hi @Rory@IBM
Thanks for your respond.
I did a new document about this work.
But, there is still one thing I don't understand and don't work.
It's based on this page : https://www.ibm.com/support/knowledgecenter/SS42VS_7.2.6/com.ibm.qradar.doc/t_cloud_member_vpn.html
The command pass but, there is nothing edit on the network.
So, what the command do ? this command create another tunnel OpenVPN and link Qradar to the other host ? It should only modify route inside Qradar ?
Kind regards,
Vincent.
The member commands are meant only to add routes from the member host through the local vpn endpoint to the remote network.